Builder

Support forum for MegunoLink
Post Reply
griiker
Posts: 19
Joined: Wed Jun 27, 2018 12:27 am

Sun Jul 01, 2018 9:12 pm

I'm trying to use the builder to just display the interface panel. I noticed in the tutorial that I can remove the docker. How do I do that?
I also have another arduino side question for you that I will make another post for.
philr
Posts: 446
Joined: Mon May 26, 2014 10:58 am

Mon Jul 02, 2018 6:25 am

Hi Griiker, what do you mean by docker?

This image
https://www.megunolink.com/wp-content/u ... erface.png

Is from our step by step guide.
https://www.megunolink.com/documentatio ... der-guide/

This is about as simple as you can make the interface. It only has a single interface panel.

Cheers
Phil
griiker
Posts: 19
Joined: Wed Jun 27, 2018 12:27 am

Mon Jul 02, 2018 3:07 pm

So how do I remove it? it is different from removing the monitor, and other visualizers.

the instructions only say to remove, but not how.

Thanks

griiker
philr
Posts: 446
Joined: Mon May 26, 2014 10:58 am

Tue Jul 03, 2018 7:38 am

Do you mean the window with all of the visualisers? You just hit the X buttons and it will disappear.
x2scrap.png
x2scrap.png (44.53 KiB) Viewed 9384 times
griiker
Posts: 19
Joined: Wed Jun 27, 2018 12:27 am

Wed Jul 04, 2018 3:53 am

Okay, that is what I thought it was. can the interface visualizer be stand alone, without the rest of the stuff, much like a pop-window?
philr
Posts: 446
Joined: Mon May 26, 2014 10:58 am

Wed Jul 04, 2018 5:31 am

Unfortunately not. It needs a way to make a connection etc.

Cheers
Phil
Post Reply