Linking variables in interface panel

Support forum for MegunoLink
Post Reply
c_fox
Posts: 1
Joined: Wed Aug 12, 2020 12:39 pm

Wed Aug 12, 2020 1:32 pm

Greetings!
I would like to ask if it is possible to bind variables in a project?
for example, I have several variables (analogRead for example), which I want to display on the chart, display on the gauge, and save to the table. I would like to do this with one command on arduino (one serial-message for each variable), and then, in the meguno interfac,. send the value to gauge, plot, table by meguno's resource, without overloading the serial port with multiple commands

thx!
admin
Site Admin
Posts: 20
Joined: Mon May 26, 2014 10:53 am

Sun Aug 16, 2020 7:47 pm

Hi unfortunately this is not currently possible.
Post Reply