I am a new member here and just starting my work with this wonderful tool
I am having a curious problem when sending data to a TIMEPLOT.
There are 2 channels defined, 'Analog' and 'Temperatures'
My messages and data are happily making it to the chart for the channel 'Analog' but having no luck with the channel 'Temperatures'
Code for creation of series:
Code: Select all
AnalogPlot.SetSeriesProperties("adc0", Plot::Magenta, Plot::Solid, 2, Plot::NoMarker);
AnalogPlot.SetSeriesProperties("adc1", Plot::Green, Plot::Solid, 2, Plot::NoMarker);
AnalogPlot.SetSeriesProperties("adc2", Plot::Blue, Plot::Solid, 2, Plot::NoMarker);
AnalogPlot.SetSeriesProperties("adc3", Plot::Red, Plot::Solid, 2, Plot::NoMarker);
AnalogPlot.Run(true);
TemperaturePlot.SetSeriesProperties("tc0", Plot::Magenta, Plot::Solid, 2, Plot::NoMarker);
TemperaturePlot.SetSeriesProperties("tc1", Plot::Green, Plot::Solid, 2, Plot::NoMarker);
TemperaturePlot.SetSeriesProperties("tc2", Plot::Blue, Plot::Solid, 2, Plot::NoMarker);
TemperaturePlot.SetSeriesProperties("tc3", Plot::Red, Plot::Solid, 2, Plot::NoMarker);
TemperaturePlot.Run(true);
Code: Select all
sDevice->printf("{TIMEPLOT:Analog|DATA|adc0|T|%lf}\r\n", analogResults[0].average);
sDevice->printf("{TIMEPLOT:Analog|DATA|adc1|T|%lf}\r\n", analogResults[1].average);
sDevice->printf("{TIMEPLOT:Analog|DATA|adc2|T|%lf}\r\n", analogResults[2].average);
sDevice->printf("{TIMEPLOT:Analog|DATA|adc3|T|%lf}\r\n", analogResults[3].average);
Code: Select all
for (itemp=0;itemp<8;itemp++){
if (peripheralStatus.tcExpPresent[itemp]==1)
sDevice->printf("{TIMEPLOT:Temperatures|DATA|T|tc%d|%f}\r\n", itemp,thermocoupleMetrics[itemp].hotJunctionTemp);
//TemperaturePlot.SendFloatData("T"+String(itemp), thermocoupleMetrics[itemp].hotJunctionTemp,1);
}
{TIMEPLOT:Analog|DATA|adc0|T|3.469012}
{TIMEPLOT:Analog|DATA|adc1|T|3.471310}
{TIMEPLOT:Analog|DATA|adc2|T|3.471378}
{TIMEPLOT:Analog|DATA|adc3|T|3.470928}
{TIMEPLOT:Temperatures|DATA|T|tc0|27.125000}
{TIMEPLOT:Temperatures|DATA|T|tc1|26.875000}
{TIMEPLOT:Temperatures|DATA|T|tc2|26.000000}
{TIMEPLOT:Temperatures|DATA|T|tc3|0.000000}
The channels are defined in the TIMEPLOT Visualiser but only the Analog channel data is being added.
All of the series are added to the chart.
Any suggestions where to look?