How do i get rid of theses error messages

Support forum for MegunoLink
Post Reply
janvanhulzen
Posts: 2
Joined: Mon Jan 21, 2019 9:17 am

Thu Jan 24, 2019 8:26 pm

When i run an interface from an installed package that i made using the builder, errors appear. I can just ignore them an make the window in which they appear smaller . The interface is working as expected but i would like to get rid of the white messagewindow. See attached second image below. I can set the axis labels using commands from the arduino. I cant set default values using the properties window in the designer app. The values are grayed out. See window below.

Thanks for any ideas on how to solve this.
Attachments
xyplotbuildererror2.PNG
xyplotbuildererror2.PNG (45.86 KiB) Viewed 225 times
xyplotbuildererror.PNG
xyplotbuildererror.PNG (71.11 KiB) Viewed 225 times
philr
Posts: 270
Joined: Mon May 26, 2014 10:58 am

Sat Jan 26, 2019 8:19 pm

Hi, I believe you have left your visualiser selection window open in the original Megunolink interface. This isn't supported in builder so needs to be closed before saving your mlpz file and creating your installer.

Cheers
Phil
Post Reply