Edit series property

Support forum for MegunoLink
Post Reply
Pelle8879
Posts: 5
Joined: Wed Mar 21, 2018 8:56 pm

Mon Dec 16, 2019 6:58 pm

I can not change the series property. when changing it goes back after a short while. Why?
It always goes back to line with symbol.
Attachments
Skärmklipp.PNG
Skärmklipp.PNG (9.29 KiB) Viewed 92 times
Skärmklipp.PNG
Skärmklipp.PNG (6.82 KiB) Viewed 93 times
philr
Posts: 304
Joined: Mon May 26, 2014 10:58 am

Fri Jan 03, 2020 11:40 pm

Hi Pelle, its probably because you are setting the line properties from the arduino end as well? This will overwrite the local changes.
Pelle8879
Posts: 5
Joined: Wed Mar 21, 2018 8:56 pm

Sun Jan 05, 2020 3:50 pm

No I am not setting any properties.

MyPlot1.SendData(F("UppAcktemp"), UAckT,"Grader");
MyPlot1.SendData(F("MidAcktemp"), MAckT,"Grader");

Is there any wrong with above?
Should i set properties maybe?
Post Reply