Arduino Due baud rate

A place to just chat
Post Reply
Dragonsired1
Posts: 1
Joined: Wed Mar 11, 2020 8:41 am

Wed Mar 11, 2020 8:53 am

Hi,
I'm currently working on a project with Arduino Due and I'm very grateful for such and amazing program as Megunolink is. Everything is working just fine but I was wondering if there's any way to increase baud rate from 115200 above. I tried all options available in Megunolink but all end up with garbage in serial monitor. There's also a native USB on Due but I don't know if that would work with Megunolink. If anyone here know anything about this just give me some suggestions. I have a lot of data sending from Arduino to Megunolink. Thank you
philr
Posts: 315
Joined: Mon May 26, 2014 10:58 am

Tue Mar 24, 2020 9:35 pm

Make sure you set the increased baud rate in your arduino program AND in the MegunoLink interface.
Post Reply