Page 1 of 1

Use severall motor with powerSTEP01_Arduino_Library

Posted: Wed Jan 29, 2020 4:23 pm
by Malronce

I recently start a project where i have to drive few step motor, we choose X-NUCLEO-IHM03A1 motor driver with an arduino uno to drive it.
I used your powerSTEP01_Arduino_Library to use them.

It's working well but i didn't find how to use more than 1 motor in the same time.
The Hardware of the two driver are configure as it's writen in this guide use.
But i didn't find what I need to change in the firmware to be able to use two motor.
It would be really useful if you could give me a clue.

Sorry if it's not the best place to ask but i didn't find anywhere else.
Sorry for my typo, English is not my first language