Reporting Number (Seq Value) Reset

Support forum for MegunoLink
Post Reply
Posts: 4
Joined: Thu Apr 15, 2021 3:17 pm

Mon Mar 28, 2022 1:29 pm


Is there a way to simplify the "Report Number (Seq Value) setting? It is a bit clunky to have users navigate to, is there any way to reset it to 1 or set it to a given number via a serial command? Alternatively, is there any way to tie the filenames to a different variable that can be modified by serial commands (i.e. have the report filenames given directly from the arduino, especially since the arduino is currently sending a "{REPORT|SAVE}" command).

Thank you,

Post Reply